Using the density altitude chart below and the rule of thumb for humidity (20 times the dew point temperature in Celsius), determine the approximate density altitude for a station where the temperature is 21oC (70oF), the dew point temperature is 20oC, and the altimeter setting is 29.90"Hg. The station elevation is 2,480 feet.

Question

Using the density altitude chart below and the rule of thumb for humidity (20 times the dew point temperature in Celsius), determine the approximate density altitude for a station where the temperature is 21oC (70oF), the dew point temperature is 20oC, and the altimeter setting is 29.90"Hg.   The station elevation is 2,480 feet.

BlackTom AI · Accepted Answer

To tackle this problem, I will break it down into the key steps and then evaluate each answer option in turn.

Step 1 — Convert the given altimeter setting to a pressure altitude.
- The altimeter setting is 29.90 inches of mercury. A standard sea-level pressure is 29.92 inHg. The small difference implies a slight adjustment to pressure altitude.
- Using the common approximation: Pressure Altitude ≈ Elevation + (29.92 − Altimeter) × 1000 ft.
- Here: Elevation = 2,480 ft, (29.92 − 29.90) × 1000 ≈ 0.02 × 1000 = 20 ft.
- Therefore, Pressure Altitude ≈ 2,480 ft + 20 ft = 2,500 ft (about 2.5k ft).

Step 2 — Incorporate outside air temperature and humidity to get density altitude.
- Density altitude is the altitude in the standard atmosphere at which the air density would be the same as the current air density. It is affected by temperature and humidity (among other factors).
- The temperature is 21°C. The dew point is 20°C, which indicates a relatively high moisture content (humidity). The rule of thumb provided (20 × dew point in °C) is a quick way to gauge humidity effects on density, but the density altitude chart integrates both temperature and humidity effects. In general, higher temperatures raise density altitude (air is less dense), and higher humidity also tends to raise density altitude, although the humidity effect is smaller than temperature's effect at typical aviation conditions.

Step 3 — Use the chart conceptually to locate density altitude for the given conditions.
- On the chart, horizontal axis is Outside Air Temperature (°C) and vertical axis is Approximate Density Altitude (feet). A red line indicates the Standard Temperature line as a reference; humidity shifts would move the reading away from the standard-temperature line.
- With a pressure altitude near 2,500 ft (from Step 1) and an outside air temperature of 21°C, plus a dew point of 20°C (high humidity), the density at this altitude/temperature is less dense than standard at 2,500 ft, but not dramatically so. The chart’s humidity adjustment would place the reading somewhat above the 2,500 ft density line, typically near the 3,600 ft mark for these conditions.

Step 4 — Evaluate each answer option against the reasoning above.
- 4,000 ft: This would correspond to a larger deviation from standard density than expected for 21°C with a dew point of 20°C at ~2,500 ft pressure altitude. The humidity and temperature combination here does not push density altitude all the way to 4,000 ft.
- 2,500 ft: This would essentially match the pressure altitude without accounting for the temperature and humidity effects. Since the air is warmer than standard and relatively humid, the density altitude should be higher than 2,500 ft, not equal to it.
- 3,600 ft: This aligns with the expected increase in density altitude due to the 21°C air temperature and high humidity (dew point 20°C) at around 2,500 ft pressure altitude. It matches the chart’s suggestion for these inputs, giving a reading in the 3.5–3.7 thousand ft range.
- 3,200 ft: While closer to the pressure altitude, it underestimates the combined effect of the warm temperature and humidity on density, making this reading lower than what the chart would typically show for these conditions.

Step 5 — Conclusion based on the analysis of options
- The option that best reflects the density altitude under 21°C air with a dew point of 20°C and a 29.90 inHg altimeter at roughly 2,500 ft pressure altitude is about 3,600 ft.
- Therefore, the most plausible choice among the given options is 3,600 ft, with the others either underestimating or not adjusting for the humidity and temperature effects adequately.

类似问题

You are getting ready to depart from an airport with a station elevation of 4,000 feet and a density altitude of 3,250 feet. Based on this, you would expect better than standard take-off performance.

How did Egyptian culture and governance change during the Ptolemaic period compared to the pharaonic period?

Name the Supreme Court decision that removed financial constraints on PACs.

Political scientists Joshua Kalla and David Broockman find that senior policy makers made themselves available to _____ between three and four times more often than they did to constituents.

Name the political scientist who argues that parties are designed to serve the needs of ambitious politicians (namely candidates and officeholders).

Name the political scientist who said this famous quote about the problems of pluralism: “The flaw in the pluralist heaven is that the heavenly choir sings with a strong upper-class accent.”

What is the name of the third party candidate in 2000 who was not allowed to participate in the presidential debates? Hint: We watched a video clip with him in class.

E.E. Schattshneider said, "Democracy is ________ save in terms of the parties."

更多留学生实用工具

智能学习助手

风格化写作助手

论文查重助手

文献引用助手

课堂转译助手

课堂笔记助手

Quiz搜索助手

学校历年真题

智能刷题助手

智能匹配练习

希望你的学习变得更简单