If you wish to communicate with an aircraft that is being pointed out to you, inform the transferring controller by stating “______.”

Question

BlackTom AI · Accepted Answer

In this question, we’re looking at the proper radio communication phrase to inform a transferring controller that you wish to communicate with an aircraft being pointed out to you. 
Option 1: '(Aircraft ID) (restrictions, if applicable) RADAR CONTACT' This option matches standard air traffic control phraseology, where you identify the aircraft and any applicable restrictions, followed by 'RADAR CONTACT' to confirm radar contact and initiate communication with the relevant controller. It directly conveys whom you want to contact and your status. 
Option 2: 'ROGER, POINT OUT' This phrase is not appropriate here. 'Rog er' is confirming receipt of information, and 'POINT OUT' is a request to describe something spotted by the other party; it does not establish contact or specify the intended controller. It could cause confusion about who is being addressed. 
Option 3: 'APPROVED, HANDOFF' This phrase implies approval of a handoff, not a request to contact an aircraft or transfer control. It’s an administrative confirmation rather than a communication request to the transferring controller, so it’s not the correct procedural wording for initiating contact.
Option 4: 'HANDOFF, RADAR CONTACT' This mixes terms in an atypical order. While 'RADAR CONTACT' is correct in some contexts, pairing it with 'HANDOFF' in this sequence does not clearly identify the target aircraft or the exact action needed to contact the transferring controller. The standard call requires the aircraft ID and any restrictions before stating 'RADAR CONTACT.'
Overall, the most precise and conventional phrase to use when you want to communicate with the aircraft being pointed out is to state the aircraft ID (and any applicable restrictions) followed by 'RADAR CONTACT' to establish contact with the appropriate controller. The other options either misstate intent, misuse terminology, or fail to identify the aircraft and contact procedure clearly.

If you wish to communicate with an aircraft that is being pointed out to you, inform the transferring controller by stating “______.”Single choice

Similar Questions

FAA Oceanic controllers use a system called ATOP. What does ATOP stand for?

An _____________ is a terminal ATC facility that provides approach control service in a terminal area. (Choose the best answer)

The primary purpose of the ATC system is the _____, _, and __________ flow of aircraft.

Which department in the FAA is responsible for the entire ATC operation?

If ZAE66 issues the clearance "cross HEDUD at one-one thousand, at two five zero knots", and then subsequently assigns a speed of 280 knots, at what speed will the aircraft be over HEDUD?

When utilizing the Enroute Decision Support Tool, what must be used as the sector team’s primary source of flight data?

An aircraft emergency is considered to exist when ________.

When initiating a vector, a controller is required to advise a pilot of the __________.

More Practical Tools for Students Powered by AI Study Helper

Homework AI Solver

Stylized AI Paper Writer

Plagiarism Checker Assistant

Citation AI Academic Writing Tool

In-Class Translation Assistant

AI Note Generator

AI Quiz Answers

Past Exam Questions from University Test Bank

Smart Practice Assistant

Adaptive Practice

Making Your Study Simpler